Mini bike chopper magneto starter how to#
How to turn off the bike properly after each ride? If the bike is cold (hasn’t been turned on for a few hours or more): Put the choke lever in the closed position (as shown in image2 with the red arrow, the lever in the UP position).If the bike is still warm: put the choke lever in the open position (as shown in image3 with the red arrow, the lever in the DOWN position) and turn the bike on as you usually would with the pull start.If this is not the first time starting the bike, open the gas valve in the vertical position (as shown in image2 with yellow arrow), allowing the gas to flow through the bike, then: It may help to give the bike a little twist of the throttle on the 3rd quick pull if the bike is hard to start. After break-in, the bike will start up with only one or two pull procedures. Starting may require several tries when the bike is still new. In certain weather conditions, you may put the choke lever in the middle or lower position to help make it easier to start. Once bike is warm, pull the choke lever in the open position (as shown in image3 with red arrow, the lever in the DOWN position).Once the bike is on, let it warm up for about 1 minute.This may take a few attempts as the bike is being turned on for the first time. On the 3 rd attempt, pull the cord quickly with the intention of turning the bike on.Pull the start cord out slowly until it reaches its maximum distance, allowing the gas to flow into the bike.Put the choke lever in the closed position (as shown in image2 with red arrow, the lever in the UP position).Wait 3-4 minutes, while sometimes rocking the bike back and forth to allow the gas to flow through the fuel lines for the first time.Turn the gas valve in the vertical position opening the gas to the bike (as shown in image2 with yellow arrow, the gas valve in the UP position).The pull start cord is on your right side. Stand the bike upright you should be sitting on the bike.Refer to “ What is the mixing ratio of gas and oil?” section for proper mixing ratio! Mix oil and gas at a 25:1 ratio using the mixing bottle provided with the bike.If this is the first time you are starting the bike: How do I properly start the bike for the first time? Please use 2-Stroke Motorcycle or Lawnmower Oil ONLY! This can be found at your local Walmart or superstore of your choice. What type of oil is recommended for this bike? Take note: You are putting in 25x more gasoline than oil. Pour gasoline first, and oil second! Use red arrow to determine which line to fill the gas up to and use yellow arrow to determine which line to fill oil up to. In your package, you have received a mixing bottle. Since this is a 2-stroke engine, you will need to mix oil and gas together. Regular unleaded gasoline works just fine, however we recommend to use unleaded premium gasoline for best performance and a healthier bike.
0 kommentar(er)
